Powering 1.0um DMOS process using single 1.5V. Possible?

Status
Not open for further replies.

kumarghz

Member level 5
Joined
Nov 25, 2006
Messages
85
Helped
10
Reputation
20
Reaction score
7
Trophy points
1,288
Location
Penang, malaysia
Visit site
Activity points
1,938
Hello guys,

I need to use 1.0um DMOS process from XFAB to design a step-up boost converter (1.5V -to- 5V).
I understand that the minimum operating voltage of this process is 5V.
Is there method to design this boost converter by using single 1.5V supply?
Please advice.

regards,
Kumar
 

As you'll probably know, XFAB's XDH10 is a very high voltage process (trench isolation, up to 650V). However, with threshold voltages <|1V| for the lower voltage transistors it should be possible to work with a (start-up?) power supply of 1.5V.

As always, the best info comes from the fab itself. Ask them!
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…