Power vs load capacitor in Hspice

Status
Not open for further replies.
T

taranom1

Junior Member level 1
Joined
Jan 19, 2011
Messages
18
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,415
Hello,

I used .data command for earning Power in various Cloads, but its Value in Transient Analysis didn't change! but for various VDDs it changes.

Should I use .Alter command?

my code:

.TRAN 10n 100n SWEEP DATA = D1
.data d1

CLOAD 3fF 3.5fF 4fF 4.5fF 5fF
.enddata
 

Thanks erikl, Sorry I was busy,
My Project is A Full Adder and I need do Several Analysis,So Should I write every Analysis in another .sp file?
as far as i knew for ac Analysis I should use ac Sources but my Sources Are Pulse.How about Mix Sources?
here is my code :
Code: 
VA  A  Gnd PULSE (0 vdd 200ps 100ps 100ps 5ns 10ns)
.
.
.

.TRAN 10n  100n sweep  data = d1
.data d1
VDD 0.5 0.65  0.8
.enddata
.
.
. 
.AC  DATA = d2
*.data d2
*CLOAD   1fF    2fF    3fF    4fF    5fF
*.enddata
********************frequency sweep***************
.AC DEC 4  100MEG  500MEG
 

taranom1 said:
... I need do Several Analysis,So Should I write every Analysis in another .sp file?
Click to expand...
Not necessary.

taranom1 said:
as far as i knew for ac Analysis I should use ac Sources but my Sources Are Pulse. How about Mix Sources?
Click to expand...

ac sources, yes. No mixed sources.

BTW: Cap power is always CV2 , isn't it?
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…