power supply problem for controller

welove8051 · May 4, 2013

hello all, i had designed simple dc voltage measurement and display(LCD) with 8051 mc for a solar inverter. the problem is when the load is connected to the inverter the lcd brightness becomes dim. i think the load is getting maximm current. how to solve this problem should i need to have any special filter to prevent the lcd dimmness? please reply.

thank you

hamidmoallemi · May 4, 2013

do you have regulator circuit for supply?

phobos1 · May 4, 2013

try placing a .1uf capacitor at lcd vcc and gnd

tpetar · May 4, 2013

welove8051 said:
hello all, i had designed simple dc voltage measurement and display(LCD) with 8051 mc for a solar inverter. the problem is when the load is connected to the inverter the lcd brightness becomes dim. i think the load is getting maximm current. how to solve this problem should i need to have any special filter to prevent the lcd dimmness? please reply.

thank you

Post circuit.

Describe solar inverter, describe where and what you measure, what voltage (battery or inverter output voltage),...

ark5230 · May 4, 2013

Also check the load in use. If it is a test load, it is drawing larger amount of current that can be afforded by your system so the voltage is dropping making the display dim. Either decrease the load or try to increase current sourcing capability of the system.

power supply problem for controller

welove8051

Full Member level 6

hamidmoallemi

Full Member level 2

phobos1

Full Member level 2

tpetar

Advanced Member level 7

ark5230

Advanced Member level 3

Similar threads

power supply problem for controller

welove8051

Full Member level 6

hamidmoallemi

Full Member level 2

phobos1

Full Member level 2

tpetar

Advanced Member level 7

ark5230

Advanced Member level 3

Similar threads

Privacy & Transparency

Privacy & Transparency