Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Power Over Ethernet Pinout

Status
Not open for further replies.
T

thaitam

Junior Member level 2
Junior Member level 2
Joined
Nov 7, 2009
Messages
20
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,436
Hey

I was wondering if anybody knew much about POE.

https://pinouts.ru/Net/poe_pinout.shtml

this website gives me a pinout which is fine but I basically want to take the +voltage pin and alter the signal so i can effectively switch the power to the ethernet device on and off.

for example
IEEE 802.3af
using spare pairs

Is it like for example that pins 4 and 5 are at 48V whilst the vport negative (DC-) are at ground (0V)?

thanks
Thomas
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top