post route simulation using Modelsim XE with ISE11

Status
Not open for further replies.
M

melexia

Member level 2
Joined
Jun 2, 2008
Messages
43
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Visit site
Activity points
1,620
Hi all,

I am trying to do post place and route simulation using Modelsim XE with ISE 11.
My code is a Discrete fourier transform implementation which contains three 1024 bytes dual port memories, and other logic for calculation of DFT.
When I run a post route simulation it takes 1 hour to simulate few hundreds of nano seconds, why is it happening?
I really need this simulation done.
Can anybody help me regarding this...........................

thanks
 

I think because speed mode of your computer and can not overcome.you should take on board the
good luck !
 

post place and route similation is very slow, and should be avoided until neccesary.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…