Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Position of TVS diode in Ethernet application

Status
Not open for further replies.
F

FreshmanNewbie

Advanced Member level 1
Advanced Member level 1
Joined
May 10, 2020
Messages
437
Helped
0
Reputation
0
Reaction score
3
Trophy points
18
Activity points
4,333
I'm going through this appnote.

My question is based on Figure 1 on page 1 of the datasheet. Am I correct in understanding that it is not correct to move the TVS diode (DBI) from the PHY side of the transformer to the RJ45 side? I feel that it is not right, based on the resistance value and capacitance of the capacitor between the transformer and RJ45 specified in the Hardware Check List.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top