port in cadence spectre for differential circuits

Status
Not open for further replies.
V

viperpaki007

Full Member level 5
Joined
Jul 2, 2008
Messages
274
Helped
11
Reputation
22
Reaction score
8
Trophy points
1,298
Location
Finland
Visit site
Activity points
3,437
Hi,

How can i use port from analogLib in cadence spectre. If i have a differential circuit of 100 ohm differential impedance, can i just directly connect port (by putting R=100 in settings) to differential input of circuit?. Will this give right results?

BR
 

Never used that feature. If I want to probe guts, I put
a vcvs and resistor, ground referred, and a schbpin to
bring the net out (if I don't just want to descend and
probe). You could also assign a unique global net name
(if this is a one-off block) and place a same-named
wire stub at any level you like.
 

I think if you don't concerned about dc level, you'll get right results.

If dc level is important issue for your circuit, you can use ideal balun from rfLib.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…