please help me in this circuits.

your1click · Jan 13, 2013

dear frns, im trying to make this ckt for USB programmer but i hav a some confusion, im posting the link in here im confused where used 1 2 3 4 5 6 number why they used?

tpetar · Jan 13, 2013

Its just marks for connectors pins, pay attention on LPT port pins and SPI port pins.

When you connect programmer to board for programming, watch that you connect appropriate pins as SCK to SCK, MOSI to MOSI, MISO to MISO, +5V to +5V, Gnd to Gnd, RST to RST.

Connect appropriate bus connections between each others, as CK to LPT port pin 6, DO to 7, ....

nitishn5 · Jan 13, 2013

The Circuit is not a USB Programmer, it just uses the USB to power the circuit. It is still using the PC parallel port for programming. The pins 1numbers 1 to 6 are related to the DB-25 connector of the parallel port.

your1click · Jan 13, 2013

and do u have a any other programmer ckt in USB mode, i want At89 series programmer otherwise universal also good.

tpetar · Jan 13, 2013

Make USBasp he can program Atmel uC ATMega serie, just as 89S serie uC.

89S51, 89S52 can be programmed over LPT without any IC:

your1click · Jan 14, 2013

no i want in USB mode...

tpetar · Jan 14, 2013

Then go with USBasp.

USB 8051 (89 series) & AVR Microcontroller Programmer
https://www.circuitvalley.com/2011/06/usb-8051-avr-microcontroller-programmer.html

Use ProgISP 1.68 software.

please help me in this circuits.

your1click

Member level 3

tpetar

Advanced Member level 7

nitishn5

Full Member level 6

your1click

Member level 3

tpetar

Advanced Member level 7

your1click

Member level 3

tpetar

Advanced Member level 7

Similar threads

please help me in this circuits.

your1click

Member level 3

tpetar

Advanced Member level 7

nitishn5

Full Member level 6

your1click

Member level 3

tpetar

Advanced Member level 7

your1click

Member level 3

tpetar

Advanced Member level 7

Similar threads

Privacy & Transparency

Privacy & Transparency