Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Plated through holes in a surface mount pad?

Status
Not open for further replies.
T

treez

Guest
Newbie level 1
I wish to have a 250V, 22uF capacitor on our PCB which we may want to be a SMT component or a radial PTH component.

Is it ok for us to place plated through holes into our surface mount capacitor pads?, so that we can fit either component?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top