[SOLVED] PIN diode DC simulation

Status
Not open for further replies.
D

distributedPA

Newbie
Joined
Apr 12, 2024
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
34
Hello, I'm currently unarchiving a 7zad file provided by Skyworks to run a simulation. During the simulation, I noticed a significant discrepancy between the current values on the diode's I-V curve in the datasheet and those in my results. Could you let me know if I might be conducting the simulation incorrectly? I'm still a beginner, so I lack a lot of fundamental knowledge.

I would be grateful for any advice you can provide.


 

Sort by date Sort by votes
I don't recognize a DC simulation circuit. Main error is caused by TermG2 50 ohm resistance, must be shorted for DC simulation. Or show diode voltage instead of Vg. To compare the curves, you should plot it the same, with semi-logaritmic scale, isn't it?
 
Upvote 0 Downvote
Hi,

the main problem is that you added a resistor in series with the diode.
thus:
* VG is not the diode_forward_voltage, and
* the current is limited/reduced by the resistor

Klaus

Added:
FvM was faster...
 
Upvote 0 Downvote
Thanks for your answer. I always design power amplifiers, I missed the basic part by trying to apply a diode in the bias circuit.
 

Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…