PICKIT2 clone with schematics and pcb in pdf format for DIY

Status
Not open for further replies.
N

naseerak

Full Member level 5
Joined
Jun 14, 2003
Messages
241
Helped
19
Reputation
38
Reaction score
19
Trophy points
1,298
Visit site
Activity points
1,222
Here is my simplified and tested pickit2 schematic with pcb in pdf format working fine for me.

- - - Updated - - -

gerbers can be posted here if any body intrested.
 

Attachments

  • PICKIT2-SCH.pdf
    36.4 KB · Views: 313
  • PICKIT2-BOT.pdf
    27.4 KB · Views: 264
  • PICKIT2-TOP.pdf
    11.2 KB · Views: 243

The top is mirrored and could do with some tidying up.

Are you going to make this board yourself or get it made somewhere cheap? You may need to adjust the size of your pads as you have a very small amount of land left after the hole which will lead to very little solder to form a good joint.

Why have you hatched the copper? It will make it harder for you to etch yourself.

What software did you use?
 

I did it using toner transfer with no problem, The full solid pattern may cause PITA for Laser jet so I decided to Hatch the patterns.

- - - Updated - - -

The mirrored Top is necessary for the silk screen, while doing toner transfer.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…