flote21
Advanced Member level 1
Hello,
Reading the datasheet, it says that the recommended power supply is 5v. However this PIC is going to be connected to a 3v3 FPGA bank, and I am wondering if there is any way to configure the I/O pins to have Vout(max)=3v3 powering the chip with 5v. Is it possible?
Thanks!
Reading the datasheet, it says that the recommended power supply is 5v. However this PIC is going to be connected to a 3v3 FPGA bank, and I am wondering if there is any way to configure the I/O pins to have Vout(max)=3v3 powering the chip with 5v. Is it possible?
Thanks!