PIC18F4431 for BLDC Motor control

Status
Not open for further replies.
O

Obosi

Newbie level 1
Joined
Dec 17, 2013
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
7
Hi,
I'm just very new in the field of Microcontroller and I will be grateful if someone can tell me on which pins I should connect my Run/stop, FWD/REV, Motor current, and temp... on PIC18F4431 microcontroller. I'm performing the task in close loop with hall effect sensors.
I will be happy for any kind of solution ideas.

Thanks.
 

Why don' you check the AN900a application note from microchip.
Its depends what you configure the port pins. PORTA all pin can be used for analog inputs, but using this chip HSADC is not easy.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…