PIC16F676 programming error programmer shows all zero after successful programing.

peter_england · Mar 26, 2013

I am confused using winpic programmer with jdm like programmer hardware (its built at home ) in programmer software it detects chip also get program chip but after reading it again it only shows all zeros in buffer area what is the problem with this ? is the programmer is bad or anything else please help me .. i am programming MICROCHIP PIC16F676 with home made serial programmer .. i am waiting someone help.

tpetar · Mar 26, 2013

Maybe you enable code protection option, try to disable option.

peter_england · Mar 26, 2013

where to set it ??

tpetar · Mar 26, 2013

In programmer software what you use.

peter_england · Mar 26, 2013

ok i checked it but its off..

tpetar · Mar 26, 2013

Try to load hex in programming software, check code protection option is off, then program and read uC after programming is finished.

peter_england · Mar 26, 2013

yes sir what a great help you have done for me thannnnnnnks very much now working fine; i will go to next step of blinking led project thanks a lot ..

PIC16F676 programming error programmer shows all zero after successful programing.

peter_england

Full Member level 4

tpetar

Advanced Member level 7

peter_england

peter_england

Full Member level 4

tpetar

Advanced Member level 7

peter_england

peter_england

Full Member level 4

tpetar

Advanced Member level 7

peter_england

peter_england

Full Member level 4

Similar threads

PIC16F676 programming error programmer shows all zero after successful programing.

Full Member level 4

Advanced Member level 7

Full Member level 4

Advanced Member level 7

Full Member level 4

Advanced Member level 7

Full Member level 4

Similar threads

Privacy & Transparency

Privacy & Transparency