[SOLVED] Pic 16f876a Pure Sinewave inverter

Status
Not open for further replies.
When downloading gets to 1.07mb it stop downloading and give an error.i 've tried re-downloading it several times but it's the same.
 

@ shegzzyy
I have downloaded it without error.
you may have some other problem.
try it some other time.
 

Hi Friends,
thank you very much for notes,
Can someone please post a schematic on a sine wave PWM circuit using a PIC16f877A because that's all i have available.
If possible post the code too.
I will greatly appreciate you.
Best regards.
TM
 

Muhumuza tinka said:
Hi Friends,
thank you very much for notes,
Can someone please post a schematic on a sine wave PWM circuit using a PIC16f877A because that's all i have available.
If possible post the code too.
I will greatly appreciate you.
Best regards.
TM
Click to expand...

you should be able to make the mods for your processor yourself dude.
if not, i suggest you should try a simpler project.

alternately, we could try and make the changes for you, assemble the system, and have it shipped to you at our own cost.
would you like & appreciate that too ?
 



i dont think you got my point: ive programmed and used pic16f84a and pic16f628a but now the change of hardware requires me to change code and schematics.
thank you for replying.
 

Coding the Pic is more important than schematics the only need for the PIC is to send (square , quasi , or pure sine wave) control signals to mosfet drivers either in low voltage or the high volt H-bridgr

it also can help in some protction, overloading , indications ,,,, etc
 

any body help me making pure sine wave Inverter cum IPS & its related all data, source code TR design , Truble shooting?
 

helo Taner ,
how R U? Can U Give Me This Design Pcb Layout?
 

@hasan, I have already shared pcb design in the zip file
 

Hi,
I did the same inverter but for 24 volts . It works stable and better then 12 volts and the power increased to more then 1000 watts.
Can someone help me to how to change the battery check option and to reduce the safety work of battery 10,5-16 V to 21-32 V.
Regards
 

coke2k said:
Can someone help me to how to change the battery check option and to reduce the safety work of battery 10,5-16 V to 21-32 V.
Regards
Click to expand...
it can be done by recalculating the value of the battery check resistors....
 

hi all
good jobs. it's 2 day long i read all the thread. you can find on all your question answer. i'll try to build:lol:
 

Can someone tell me the oscillation output pins from micro-controller .
 

I think it will be very helpful to add a nice three stage battery charging to the code, as to some extend the hardware requirements are sufficient.
 

Jami007,
Can you please tell me the oscillation output pins in the microcontroller. Because I wanted to design charge and change over the inverter.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…