Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

PCI2.3 technical help is needed.

Status
Not open for further replies.
H

hawk

Member level 4
Member level 4
Joined
Nov 27, 2001
Messages
76
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,288
Activity points
384
pci2.3

Hi fox,
Need to know if pci 2.3 can be configured to work with 16bits bus????
also need to know, Can the mini pci (16bits bus) work in this configuration (I assume so...., but i need clarifications) with regular pci bus??

Lots of regards,
Hawk. :roll:
 

byte enable pci2.3

:eek:No!PCI is a 32 bit bus protocol.MiniPCI is 32 bit bus too.
 

Yes

PCI can be used with 16 bit based on byte enable active.
 

No, not true
There is no data path redirection from high 16 bits to low 16bits, except you use each low 16bits location for each double word address. But that is very strange.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top