Ranbeer Singh
Full Member level 5
- Joined
- Jul 30, 2015
- Messages
- 259
- Helped
- 22
- Reputation
- 44
- Reaction score
- 22
- Trophy points
- 1,298
- Location
- Faridabad India
- Activity points
- 3,266
Anybody can explain me how use copper pour in power circuit PCB.
I read in a book "As an example, instead of using separate power planes, you can just pour copper connected to GND over one side of the board and VCC over the opposite side – so called “multi layer simulation”. Even if you have separate power planes extra shielding is highly recommended. But i am unable to understood it.
What is benefit of it?
I read in a book "As an example, instead of using separate power planes, you can just pour copper connected to GND over one side of the board and VCC over the opposite side – so called “multi layer simulation”. Even if you have separate power planes extra shielding is highly recommended. But i am unable to understood it.
What is benefit of it?