PCB Design using PCBWEB

[Lironsh]

Hello,
Is there anyone using PCBWEB for PCB Design?
I'm trying to make a footprint for TH component which has a Rectangular pad, and I can't figure out how.

This is the datasheet:
https://www.cui.com/product/resource/digikeypdf/pj-003a.pdf

Should I make TH pad as Round even though it's not following the datasheet? what are the consequences?


Thank you
Liron

 

[marce]

You can use slots and racecourse shaped pads..... for the soldered pins and plain slots for the two location tabs.....

 

[Lironsh]

Thank you for the reply,
when you mention racecourse, do you mean using the PLine and make my own shape?
How do I set it as slot? There are these options: (FpSurface | FpMask | FpPaste |FpSilk |FpAssy)

I didn't see support on www.pcbweb.com

Thanks,
Liron