pc to pic32 using USB interface with matlab

Status
Not open for further replies.

gupta2000

Newbie level 3
Joined
Mar 27, 2013
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,302
Hello all...i am trying to interface microchip pic 32 usb starter kit pc using matlab....i am finding difficult how to identify the port that was connected to PC and to write the matlab code for the interface...if anyone have information please post the reply
 



i had tried that, but i didnt see any changes in the device manager (USB controllers) when i connect and disconnect the microchip board....i had installed microchip software in my pc and when i try to work with the board using c program, it was working........do i need to install any other drivers on my pc??

- - - Updated - - -

even in the ports i dont see any USB connection
 

Do you know programming
means are you expert or have some knowledge of 8 bit pic


what i am guessing is that you have not programmed your controller with the appropriate code thats wjy this happens.
if you are new try basic programming then go to usb
 

no i am not new...i did programming before....but i dont have a clear idea about the work i am doing now....

- - - Updated - - -

ok then can you suggest me how to learn programming USB connection??
 

Status
Not open for further replies.

Similar threads

Cookies are required to use this site. You must accept them to continue using the site. Learn more…