micard
Member level 3
- Joined
- Oct 14, 2009
- Messages
- 66
- Helped
- 2
- Reputation
- 4
- Reaction score
- 1
- Trophy points
- 1,288
- Location
- Soenderborg
- Activity points
- 1,659
Hi!
I was looking through internet and forums, but I couldn't find the answer for the question:
Can I make sub circuits/hierarchical blocks in Multisim 10 which will have parameters changeable in properties dialog box?
I would like to have a resistor in subcircuit, which's value could be changed without going into schematics. Or even two resistors with values will depend on one input parameter. e.g. I would like to input the gain of inverting amplifier, and the values of both resistors will change with respect to given formulas.
It would be even better if those could be changed during simulation like e.g. potentiometer.
Thanks in advance,
Micard
I was looking through internet and forums, but I couldn't find the answer for the question:
Can I make sub circuits/hierarchical blocks in Multisim 10 which will have parameters changeable in properties dialog box?
I would like to have a resistor in subcircuit, which's value could be changed without going into schematics. Or even two resistors with values will depend on one input parameter. e.g. I would like to input the gain of inverting amplifier, and the values of both resistors will change with respect to given formulas.
It would be even better if those could be changed during simulation like e.g. potentiometer.
Thanks in advance,
Micard
