simi.l
Newbie level 2
setting parameters in cst
Hi,
I trying to design a RFID antenna for 13,56Mhz in CST Microwave Studio.
I designed several antenas as a (https://www.cst.com/Content/Applications/Article/RFID+Reader-Coil,+13.56+MHz)
but I'm not sure if generated result(S-Parametr,Smith Chart,Polar Plot,Farfields an other) from CST Studio is correct.
I'm not sure if I goot set ports,field,boundary conditions,transient solver and other parameters.
Please, can any one check or corrections mistakes if you send *.cst file ?
Thank you for your help.
simi.l@seznam.cz
Hi,
I trying to design a RFID antenna for 13,56Mhz in CST Microwave Studio.
I designed several antenas as a (https://www.cst.com/Content/Applications/Article/RFID+Reader-Coil,+13.56+MHz)
but I'm not sure if generated result(S-Parametr,Smith Chart,Polar Plot,Farfields an other) from CST Studio is correct.
I'm not sure if I goot set ports,field,boundary conditions,transient solver and other parameters.
Please, can any one check or corrections mistakes if you send *.cst file ?
Thank you for your help.
simi.l@seznam.cz