flypeyton
Newbie level 5
- Joined
- Mar 2, 2009
- Messages
- 10
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,281
- Activity points
- 1,352
I want to separate some power ground traces from the ground plane when doing pouring. In the design rule, I selected "net" and chose the "gnd" net and set the same net clearance of "trace" to 0.2mm. But when doing pouring, the ground traces are still covered by the ground plane.
In Allegro or Altium, it is much easier to set the same net clearance of "trace" to "plane". Any idea how to do it in PADS Layout?
In Allegro or Altium, it is much easier to set the same net clearance of "trace" to "plane". Any idea how to do it in PADS Layout?
Last edited by a moderator: