Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Overmolded cable pull-out force

Status
Not open for further replies.
V

Visitor

Newbie level 1
Newbie level 1
Joined
May 2, 2008
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,287
I am looking at a design that uses an overmoulded cable strain relief trapped between the two shell parts of an enclosure. I am trying to estimate real world pull-out force requirements. Anyone familiar with the industry standards or typical test requirements ? The cable is a standard sub-miniature 6 -core cable with PVC insulation with outer diamter of 3.7mm. (It looks very similar to the cable on a PC mouse)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top