Output matching network (microstrip lines)

Status
Not open for further replies.

jayce3390

Full Member level 6
Joined
May 22, 2007
Messages
351
Helped
29
Reputation
58
Reaction score
21
Trophy points
1,298
Activity points
3,287
Hi all ,

I would like to know your opinion about output matching of power amplifier design.
I am designing a power amplifier and from 50 ohm I need to get short circuit at H2 and open circuit at H3 and at the same time I have to match my power amplifier to the optimal load impedance (28.8+j4.65) at the fundamental frequency at the current source level.

I encounter some difficulties to get these three conditions at the same time with microstrip lines (adding stub lines), do you think it's possible or not?

I give you a little picture to explain my wish.

thank you
 

Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…