OrCAD simulation problem

Status
Not open for further replies.
D

dkace

Full Member level 6
Joined
Jun 13, 2002
Messages
395
Helped
32
Reputation
64
Reaction score
7
Trophy points
1,298
Location
Greece
Activity points
3,562
Hi,
I am trying to simulate a circuit and it a very important parameter is the power disippation ( and the current) on the load. I noticed that I have completely different readouts when I put 100k for the load resistor and 0.1M . In any case M makes big differece with k even if the value is practically the same.
Has anyone encountered the same problem? How did you solved it and which reading is to be trusted?

D.
 

actually orcad would try to compensate for tolerances and using 0.1 M rather than 100K makes a bigger tolerance
 

Ok, understandable, but I get completely different readings! How Can I avoid this is the question.

D.
 

Use 'meg' to refer mega and not 'M' as PSPICE treat 'M' as milli.

That's why you get a big difference.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…