ORCAD Capture: Problem with grid between Orcad 10.3 and 15.7

[paulojfonseca]

orcad capture 10.3

Hi to everyone,

I recently changed the version of my Orcad Capture software from 10.3 to 15.7.

When i open in Capture 15.7 drawings made in 10.3 version, i notice that the parts are not anymore alligned with the grid, there is a bit of offset in X and/ or Y direction. This is a bit anoying when i'm editing the schematics, because the pointer is allways snaping to the grid.

Is there any configuration i need to change in Capture 15.7 to solve this problem?

Regards
Paulo

 

[paulojfonseca]

orcad capture grid

Problem solved! I was using a Grid twice as big in ORCAD 15.7.
To Change it:

OPTIONS -> PREFERENCES -> GRID DISPLAY -> GRID SPACING
And aligne this value with the value in which the Schematic was developed.

Regards
Paulo