chuzkin
Junior Member level 2
Hi everybody.
I am making a schematic in capture cis but when i run BOM, the following error appears:
ERROR [NET0016] There is no association for file %s. Configure this in the File Manager.
BOM Done.
Also, when I double click any part in schematic (to access PROPERTY EDITOR), and then try to close with X at the up right corner, the following message appears:
ORCAD CAPTURE
DENIED ACCESS TO A UNNAMED FILE
And when trying to close CAPTURE CIS, the same message appears repeteadly and can not close (I hace to force using task manager).
Version is ORCAD 9.0
Best regards.
I am making a schematic in capture cis but when i run BOM, the following error appears:
ERROR [NET0016] There is no association for file %s. Configure this in the File Manager.
BOM Done.
Also, when I double click any part in schematic (to access PROPERTY EDITOR), and then try to close with X at the up right corner, the following message appears:
ORCAD CAPTURE
DENIED ACCESS TO A UNNAMED FILE
And when trying to close CAPTURE CIS, the same message appears repeteadly and can not close (I hace to force using task manager).
Version is ORCAD 9.0
Best regards.