optocoupler interfaced with micro controller

GOWRISHANKARSL · Feb 5, 2013

Hi
I am doing project in opto coupler.In that project opto coupler is interfaced with micro controller.That opto coupler is producing the logic 1 when it is given with 1.6V.Can you please specify the opto coupler which should produce logic 1 only after 11V....

nitishn5 · Feb 5, 2013

I think you are driving the diode of the optocoupler directly .
You can use a comparator to compare with 11V and give its output to drove the optocoupler.

ard · Feb 5, 2013

Put a 10k pot between the drive stage and the opto input; keep increasing the resistor till the opto reacts. Measure the resistance at this stage and replace the pot with a fixed resistor close to the value you measured.

optocoupler interfaced with micro controller

GOWRISHANKARSL

Newbie level 5

nitishn5

Full Member level 6

ard

Full Member level 5

GOWRISHANKARSL

Similar threads

optocoupler interfaced with micro controller

GOWRISHANKARSL

Newbie level 5

nitishn5

Full Member level 6

ard

Full Member level 5

Similar threads

Privacy & Transparency

Privacy & Transparency