On chip balun single ended to differential

Status
Not open for further replies.
A

analog_ambi

Member level 1
Joined
Jul 19, 2011
Messages
39
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Visit site
Activity points
1,560
On chip balun for single ended to diff
Today at 12:14pm Quote Modify
Hi,
I am using a balun to convert single ended signal (from signal generator) to differential (onchip).

1. Is it necessary to ground the center tap of secondary? I am AC coupling the differential.

2. Since sig gen has 50 ohm impedance i have put a 50 ohm in parallel with primary.


 

In this situation the center tap of the balun should be connected to the ground. Either, direct connection or using a decoupling capacitor.
 

But the sig gen will have 50 ohm resistance right? Is it not required to match?
 

-50 Ohm is required because it creates a frequency independent but lossy termination, NOT matching.Termination is also important, otherwise the reflected wave through generator will impact the generator.( Protection,stability etc.)You can not really provide matching for all frequencies with a transformer winding, its impedance is variable in a wideband.
-If "Pseudo Ground" point is connected to real GND, the transformer will supply real differential with zero mean value.Otherwise the signals may have assymetric waveform because of nonideal windings and couplings.
 
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…