Adam8198
Newbie level 1
- Joined
- Dec 22, 2012
- Messages
- 1
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,281
- Activity points
- 1,290
Hi guys,
Merry Christmas! I am newbie here and I would like to use the Xilink white gaussian noise generator in Simulink under 2012a matlab to generate the noise for my calculation. In the System Generator for DSP reference guide "UG639 (v 13.4) January 18, 2012", it mentioned that the WGNG was built based on 'A. Ghazel, E. Boutillon, J. L. Danger, G. Gulak and H. Laamari, Design and Performance Analysis of a High Speed AWGN Communication Channel Emulator, IEEE PACRIM Conference, Victoria, B. C., Aug. 2001.
The block only has input of "reset" and output of noise, requirement is to put in seed number.
My question is I would like to set up an enable input, so I could activate from a controller or ublaze. Is this possible or I need to generate my own WGNG? Thanks for your guide.
Merry Christmas! I am newbie here and I would like to use the Xilink white gaussian noise generator in Simulink under 2012a matlab to generate the noise for my calculation. In the System Generator for DSP reference guide "UG639 (v 13.4) January 18, 2012", it mentioned that the WGNG was built based on 'A. Ghazel, E. Boutillon, J. L. Danger, G. Gulak and H. Laamari, Design and Performance Analysis of a High Speed AWGN Communication Channel Emulator, IEEE PACRIM Conference, Victoria, B. C., Aug. 2001.
The block only has input of "reset" and output of noise, requirement is to put in seed number.
My question is I would like to set up an enable input, so I could activate from a controller or ublaze. Is this possible or I need to generate my own WGNG? Thanks for your guide.