Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

New card Ethernet ENC28J60 – as a module for a set

Status
Not open for further replies.
V

Vermes

Advanced Member level 4
Advanced Member level 4
Joined
Aug 2, 2011
Messages
1,163
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,316
Activity points
22,318


Assumptions of the module:
  • can be plugged in the ISP connector for programming the processor
  • can operate as an independent Ethernet module
Two additional jumpers were placed on test board. They can immediately address e.g. IRQ of the card to the CPU Atmega16/32/644 INT2 input and the SS pin of the processor to the CS input in the ENC chip.

68_1271689044.jpg


Yellow diode flashes after plugging to the switch:



The picture shows how to plug the device to the start-up kit:



How to connect the programmer e.g. USBASP:



Schema:



A library module for Eagle created to fit the network card on the plate.



And the schema:



Link to original thread (useful attachment) – Nowa karta ETHERNET ENC28J60 - jako moduł do zestawu
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top