Neeed MTB-230 LCD Driving codes via Microcontrollerfffffff

Status
Not open for further replies.

crackerboy

Junior Member level 3
Joined
May 11, 2004
Messages
28
Helped
106
Reputation
214
Reaction score
104
Trophy points
1,308
Location
€'TR'U-2017
Visit site
Activity points
194
Neeed MTB-230 LCD Driving codes via Microcontroller

Hi,
I want to drive MTB-230 series 128x64pixels COG(Chip-on-Glass) LCD with 0.50mm Pitch FFC/FPC connector using a MCU!
Is there anyone has knowledge how to drive this LCD? I am looking especially for C code library for driving it.


Thanks for your interests... ;-)

Here is the datasheet of MTB-230 LCD manufacturer :http://www.lcd-modules.com/COG-graphic-modules.htm
Here is the datasheet of COG Driver IC (HT0313A): HT0313A.pdf
Here is the datasheet of MTB-230 LCD datasheet: NMTB-F000230FWHSGW-11A.pdf
 

Attachments

  • MTB-230-LCD.jpg
    60 KB · Views: 269
  • Tomato_LSI_HT0313A.pdf
    1.1 MB · Views: 234
  • NMTB-F000230FWHSGW-11A.pdf
    321 KB · Views: 236
Last edited:

You're going to want to look in the LCD driver chip datasheet. Under section 6 gives you interface options and tells about a serial or parallel mode for communication. Depending on your LCD background, you should be able to determine the communication and RAM commands to send to work with the device. If you are new to this then you are going to want to look into some application files to see how and where data is clocked into LCD screens to allow it to work.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…