~MJS
Junior Member level 2
Hello All,
I am trying to simulate a full bridge converter with synchronous rectification (schematic.bmp). I would like to monitor the gate signals to the transistors, but the scope does not appear to pick up switch signals.
I found a not so elegant work around (see the mess circle red in schematic.jpg). I was wondering if there is some easier way.
The problem seem to be the output of the alpha control (see subcircuit.jpg).
Any suggestions would be greatly appreciated.
I am trying to simulate a full bridge converter with synchronous rectification (schematic.bmp). I would like to monitor the gate signals to the transistors, but the scope does not appear to pick up switch signals.
I found a not so elegant work around (see the mess circle red in schematic.jpg). I was wondering if there is some easier way.
The problem seem to be the output of the alpha control (see subcircuit.jpg).
Any suggestions would be greatly appreciated.