[PIC] Need Help to Programme PIC32MX360F512L (Device ID 000000000000 error)

Status
Not open for further replies.
A

addy80

Newbie level 4
Joined
Feb 14, 2010
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Pakistan
Visit site
Activity points
1,320
Dear friend,

I am a bit familiar with the PIC18 series controller. I am trying to use PIC32MX360F512L controller. When I am trying to programme the controller with the PRESTO programmer, device id 00000000000000 error is displayed. I have powered the controller according to the specification.

I need suggestion from you.

Hope to see a response from you.

Regards.

Adnan
 

usually device ID 0 indicates the programmer is not connecting to the device correctly

do you have the PIC32 circuit?

what version of MPLAB and compiler are you using?

it may be worth getting onto PRESTO support?
 

Thank you for your prompt reply ...
Yes I have the PIC32 circuit which I designed and I will upload the schematic within a week as I am in outside my city.
I am using MPLAB IDE v8.30 with C32 compiler from Microchip.
How I can get support from PRESTO???
 

may be worth upgrading to the latest MPLAB (I think it is V8.89) or even MPLABX (you may not have a driver for it though)

if you onto the ASIX site there is a link to support
http://tools.asix.net/prg_presto.htm

I always find that it is worth looking a Microchip's user guides for their kits as the guides usually have schematics of the circuit, e.g. PIC32 Start Kit user guide
**broken link removed**
 

Thank you for your suggestion .. i am sharing the schematic of the my PIC32MX360F512L circuit. Please have a look on it and suggest me if i have done any thing wrong ....
 

sorry i am doing some mistake in uploading the image... can you tell me how to upload picture or image please???
 

Use the Add an Image button below or the following link:

Add an Image

If the image is on your system, use the select files button, then check thumbnail and click Upload, once the image is uploaded copy and paste the BBCode into your reply.




BigDog
 

The schematic looks O.K. Are you reasing recent UP software version for the PRESTO programmer?
 

as FvM says schematic looks OK
have you an oscilloscope to look at MCLR, SDA and SCA to check the signals look correct
 

Thank you FVM and horace1. I am using UP 2.54 version of software. And I will check the status of MCLR, SDA and SCA pins.
 

According to UP release notes, the chip should be supported since V2.38. So there's probably a different problem. Updating to the newest programming software won't hurt, however.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…