Need help identifying device

[Stephguim]

Can someone tell me what it is I am not professional in electronics and I have trouble with my spreader motor

 

[FvM]

It's most likely a NTC (negative temperature coefficient resistor), e.g. used for inrush current limiting.

The part looks healthy, what's its role in the motor circuit, which problem do you observe?

 

[Stephguim]

It’s from my spreader motor and this part was not welding good so I fix it but after when I push my button start he always turn but suppose to do an half turn and stop and same when I push start half turn and stop but now always turn but doesn’t stop

 

[barry]

It’s from my spreader motor and this part was not welding good so I fix it but after when I push my button start he always turn but suppose to do an half turn and stop and same when I push start half turn and stop but now always turn but doesn’t stop

So what makes you think this component, rather than ALL the other components is the problem?

 

[Stephguim]

No if you read what I say I never say this is my trouble I just explain what is my trouble and what I see and fix it and that’s only what I do now

 

[FvM]

Not clear what you did "fix". Is it related to the shown part?

 

[Stephguim]

Like I say in my message the ntc was not welding good so I welding (fix it) again after he’s welding good my motor turn but not stop like I explain earlier

 

[Stephguim]

Anyway I send to electronic repair because it’s not here I will got help
Thanks FVM

 

[barry]

sounds like you didn't fix anything. Was it really unsoldered from the board? What was the motor doing BEFORE you resoldered the part?

(It's called soldering, not welding)

 

[Stephguim]

Yes it’s okay now I say to the guy same like I say here and he call me 2 hour after and my motor are okay now….
Ps: sorry for my mistake I say welding not soldering so sorry