need an Active Voltage divider for the circuit

Status
Not open for further replies.
Z

zhaoxhts

Newbie level 1
Joined
May 1, 2015
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
8
Hello.
I'm trying to design a circuit using active voltage divider(with op amps) instead of a passive one, because i'm use the same channel for both CAN signal and Programming voltage, and the passive voltage is in this channel, and is somehow messing with CAN signal. i already fixed the problem for now, but still need an active solution. any help?
 

Hi

Can you show us a schematic about your problem?
And a more detailed description. Feel free to use values like volts, amperes and ohms rather than a textual description.


Klaus
 

Use a fixed series resistor followed by a selection of shunt resistors, each being switched in by a CMOS transmission gate t(4066). This sort of arrangement can deal with 0 to +15V signals with a impedances of say, 100 ohms to 1M ohm ay 10s of KHZ
Frank
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…