Must the L>>C in the parallel resonant circuit??

Status
Not open for further replies.

ZengLei

Full Member level 1
Joined
Jan 24, 2006
Messages
99
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
WuHan China PR
www.rigolna.com
Activity points
2,143
I want to design a radio myself,
so it need a LC parallel resonant circuit to filter the wave

Must the L>>C in the parallel resonant circuit??

Thanks~~~~~
 

The usual values for L and C are chosen to give acceptable quality factor (low loss) at the working frequency ( series resistance << reactance << isolation resistance). This means reactance between tens of Ω and hundreds of Ω.

If you want to design a radio for brodcasting, you will use a standard variable capacitor, maybe taken from another radio. This will have some sections in tthe range:
- tens of pF - 200...500pF for LW, MW, low HF;
- few pf - 20pF for FM band;
- 10pf-100pF for HF, rarely.

After you choose a variable capacitor value according to band, you can determine the L value.
L>>C in all cases (L~µH,nH , C~pF).
 

    ZengLei

    Points: 2
    Helpful Answer Positive Rating
the L and C should be in a series resonant circuit in series from the antenna or should be in an parallel resonant circuit in parallel between the signal path and ground...
 

    ZengLei

    Points: 2
    Helpful Answer Positive Rating
Often L is way greater than C because L has Henry as Unit and C has Farrad as a unit.
e.g. for about 400MHz L will be in nH and C will be in pF.
 

The ratio between L and C defines the impedance of LC circuit, which affects the matching of the filter. So , it depends on the rest of the circuit, which value you need. The impedance of this filter is defined by: Z = sqrt( L / C ). So the bigger the inductance, and smaller the capacitance, the bigger the impedance of the filter.
 

Talking about L>>C has no sense. In resonance the reactances are equal.
ωL=1/(ωC)
Quality factor or bandwidth of tank determines values of these reactances.
 

Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…