Multiband matching of full wave rectifier

S

sizo0708

Newbie level 4
Joined
Aug 15, 2024
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
72
Hello everyone,
I have a task to create a simulation in ADS of a full wave voltage rectifier with a multiband/wideband matching.
In the input I used the P_nTone with 4 frequencies: 1.8GHz, 2.1GHz, 2.45GHz, 2.6GHz.
After that comes the matching network which is my issue here, I want to design it so that it will match the circuit to 2 frequencies which are 1.95GHz (center frequency between 1.8GHz and 2.1GHz) and 2.52GHz (center frequency between 2.45Hz and 2.6GHz).
Lastly, the full wave rectifier with a load ressistor come right after the MN.
How can I perform the matching? Can you provide me with methods and maybe even illustrations if you may?
The circuit along with the impedances in the desired frequencies below:

 

Sort by date Sort by votes
You have to design a Matching Circuit so that while one branch of this Matching Circuit exhibits a Open Circuit for Band 1, the other branch will match the impedance for Band 2 to Rectifier Circuit and vice versa. Either you can use consider 2 Dedicated Parallel Matching Circuit OR Wideband Matching Circuit that is pretty difficult to realize.

Two associated Filter might be your starting point. OR A Diplexer+Matching Circuit
 

Upvote 0 Downvote
Thank you very much for the reply!
I am not sure about what you said because from my knowledge it is important that the frequencies will be far apart from each other, while in my case of 570MHz difference its not enaugh.
Also, I am not familliar with what you said about the two associated filters so if you can elaborate on that it can be helpful.
 

Upvote 0 Downvote
You must log in or register to reply here.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…