MSP430 JTAG Programming Requirements

[anaoum]

msp430f programming tool

Hello,

I am using the jtag programmer from olimex and i was wondering what are the target circuit requirements if i just want to program it. (eg does the target require a crystal)

thanks

 

[kot_b]

msp430 jtag programmer

I am using TI jtag tool. By my opinio only two things needed:
1.) About 5.6k resistor from TEST pin to groung.
2.) About 100n capacitor on power(pin 2)

 

[Taro]

msp430 jtag programming

Try thid link
https://www.olimex.com/dev/index.html

Starter kits circuit can help you, I think.

 

[rasha]

msp430 jtag programmer

I was using TI programming tool ...

As I recall not all of MSP430F devices require pull-down resistor on TEST, but putting one won't hurt.

Depending of your programming tool capabilities you should consider supplying power to target from jtag or connecting target's supply to jtag sensing input.

Crystal is not needed (actually you don't need crystal at all since there is RC oscillator on-chip ... not very accurate though ... ). It is not present on TI's development boards (as a default).

For details look for: Programming a Flash-Based MSP430 Using JTAG Interface (slaa149.pdf by TI).

All the best ...

 

[anaoum]

What about the capacitor??


thanks

 

[rasha]

Well ... the capacitor that kot_b mentioned is decoupling for supply. It is supposed to supply high frequency currents into supply pin of MSP. When processor is running it should be used, but can't be sure if it is absolutely necessary for programming purposes.

I would put it, to spare myself from chasing the wind if for any reason glitching occurs on supply line coming from JTAG (and that could easily happen if wires are long ).

Don't know what you are doing, but I would suggest using on-board (simulating the program in simulators and then programming the processor is too restrictive for me, so it should be used only for testing basic ideas in the beginning of the project) programming and debugging since it is (in my opinion) the best way to develop the program.

All the best ...