[SOLVED] [Moved] LPC2148 was not reset? [URGENT]

Status
Not open for further replies.
A

amayilsamy

Advanced Member level 1
Joined
Feb 5, 2013
Messages
420
Helped
38
Reputation
76
Reaction score
34
Trophy points
1,308
Location
Chennai,India
Visit site
Activity points
3,370
I'm using LPC2148.

Its not reset. And I also checked the crystal Pins CRO There was no signal.

How to I check it Controller is good?


Kindly help . Its most urgent....
 

Observing the signal from a crystal typically requires an active MOSFET scope probe.

Using a standard probe can easily cease oscillation of a crystal or at the very least dramatically change its characteristics and frequency.

Are you able to establish communications with the device using ISP or JTAG?


BigDog
 

You typically won't get a signal from the crystal with standard probes.

So can you establish communications with the device using ISP?

Also is this a development board?

If so, what is the manufacture and model?


BigDog
 

It is my own development board .

I already programmed and executed using this board. On that time it was good. I programmed more or less 10 times.

But now it was not working. I can't find what is the problem.
 


Here I posted error message during program time.

And also I try to erase the controller same error occurring.

 

Attachments

  • sh.bmp
    3 MB · Views: 88

Crystals typically do not fail without some physical damage.

What is the crystal frequency?


What are you using to power the development board? Is the power supply well regulated?

Can you post a schematic of your board?

Do you have pin 51 connected to Vcc (3.3v)

FlashMagic has entire page dedicated to AutoBaud Fail error message:

Failed to AutoBaud


BigDog
 

I tried to increase and decrease baud rate , again the same error occur.

I think controller was gone out. So I changed the controller in same board.

It was working good.

I don't know. Why the previous controller was not working.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…