Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Mosfet Inductive load Issue

Status
Not open for further replies.
S

satiz

Member level 5
Member level 5
Joined
Jun 9, 2013
Messages
87
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,288
Activity points
1,999
Hi All,

I am planning to drive my DC Inductive load using mosfet, load voltage 24 load current is 500ma Max.
While driving the load my mosfet is getting heat. Why it is getting so much heat. My schematic is given below for reference. Please tell me why my mosfet is getting heat and how can I avoid that?

Mosfet driver.png
 
Last edited:

It is a p-channel mosfet. How it can works? Why the ground in top? Is it your first schematic?
 

Hi,

I am planning to drive the load at low side using P channel mosfet, that's why ground is in top.
 

Then the load should be connected after transistor, not before.
Top - I mean that schematics looks incorrect.
 

Well, it wouldn't suprise me if your mosfet is not to happy with 24 Volt on its gate.
This mosfet has it specified at 20 Volt.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top