Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

MOSFET driving Problem

Status
Not open for further replies.
F

FMradio

Member level 3
Member level 3
Joined
Nov 24, 2009
Messages
58
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
Heaven
Activity points
1,672
Hello sir
I am facing a little problem in my DC motor speed control project. when i connect the oscilloscope probe with the Gate of the MOSFET its show the pulses but it looks like the pulses have some high voltage spikes as shown in the picture. How to suppress these spikes ???

Circuit.JPG

Oscilloscope.JPG
 

Hey gentleman!
Hi
It is simple! you can use an snubber network in parallel with DS junction of your mosfet . ( is this wave form , for the DS ?) but in fact these are (spikes) not important! you can use an eliminator filter that is series with your motor (LC LPF) to optimize its behavior as well as.
Best Wishes
Goldsmith
 

sir one more question do we need 4-snubber networks in full H-Bridge ??
 

Dear FMradio
Hi
Yes you should use 4 snubber network for H bridge arrangement.
Best Regards
Goldsmith
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top