TXBDan
Junior Member level 1
- Joined
- Jul 30, 2013
- Messages
- 16
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1
- Activity points
- 156
Hello all,
I'm currently working to create a spice simulation part for a OP-270 dual opamp chip. I'd like the model to include both opamps in the chip, U1A and U1B so that i can properly number my schematic, but still simulate it.
As a test, I created a part based on the basic pspice OP27 part and added the simulation model by adding a PSPICETEMPLATE property and setting the Implementation Type to pspice model. This seems to work fine.
I'm now trying to convert the "standard" OP270 part to use the OP27 simulation model, but it isn't working. I of course have more pin numbers to deal with on the dual opamp package part.
How should i go about doing this?
Thanks a lot
I'm currently working to create a spice simulation part for a OP-270 dual opamp chip. I'd like the model to include both opamps in the chip, U1A and U1B so that i can properly number my schematic, but still simulate it.
As a test, I created a part based on the basic pspice OP27 part and added the simulation model by adding a PSPICETEMPLATE property and setting the Implementation Type to pspice model. This seems to work fine.
I'm now trying to convert the "standard" OP270 part to use the OP27 simulation model, but it isn't working. I of course have more pin numbers to deal with on the dual opamp package part.
How should i go about doing this?
Thanks a lot