Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

MIPI CSI2 on-chip termination resistor

Status
Not open for further replies.
F

flote21

Advanced Member level 1
Advanced Member level 1
Joined
Jan 22, 2014
Messages
411
Helped
1
Reputation
2
Reaction score
3
Trophy points
1,298
Activity points
5,595
Hello guys!

I am working with an old design based on DM385 (Texas Instruments). I have reading all the datasheet and I am the wondering if this part is provided with an on-chipf the termination resistor for MIPI CSI2 receiver interface? As far I could check of this protocol, it is neccesary to add a 100ohm termination resistor between P&N of every channel in the receiver side.

Can anyone hlelp me with this topic, please? I have asked to Texas Instruments and they did not give any clue regarding to this issue:


Greetings
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top