milisecond delay circiut

Status
Not open for further replies.
E

Ed99

Newbie level 2
Joined
Oct 11, 2012
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,293
Hi,

I need an electronic circuit that should give 600mA-700mA current to a resistive load (1ohm-2ohm).
However, the current should flow through the load 5 miliseconds after 5V input is applied to the circuit.
Any help greatly appriciated.

Ed.
 

Barry,
Thanks for the reply.
I just need a turn-on delay.
 

There are a LOT of ways you can do this; a simple R-C going into a schmitt trigger is one. The output of your schmitt trigger can drive the gate of a MOSFET (or the base of a BJT).
 

Hi,
You can make a monostable with 555 and a series pass NPN transistor on its output to handle the load
 

Following the idea suggested by Barry (post #3)...

Here is a schematic showing how a series RC combo can deliver a delayed hi or lo signal, after power is applied. Scope traces tell the story.

 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…