Mikroc Library functions for PIC12f683

Status
Not open for further replies.

imranahmed

Advanced Member level 3
Joined
Dec 4, 2011
Messages
822
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,298
Location
Karachi,Pakistan
Visit site
Activity points
6,533
This code is compiled successfully but the data do not send out in serial LCD or Virtual Terminal.
 

Attachments

  • OW.txt
    136 bytes · Views: 81

This is your code:
Code: 
void main()
{
ANSEL=0;
CMCON0=0;
CMCON1=0;
TRISIO=0;

 T1CON=0;
 T2CON=0;
 IOC=0;
while(1)
{
Ow_Write(&GPIO,0,0x41);
}

}

You used the One-Wire Protocol.

Can you upload your schematic?

You can't send data directly to Virtual Terminal with One-Wire Protocol. You need to use RS232 (UART).

To send data to LCD or Virtual Terminal via One-Wire Protocol, you'll need some chip that "converts" the data sent through One-Wire to something suitable for sending to LCD or Virtual Terminal.

Hope this helps.
Tahmid.
 
Attached schematic of One-Wire Protocol.
I learn in OW datasheet that OW-Protocol uses Pulse Width Modulation method thats why is not showing data in LCD or Virtual Terminal.
 

Attachments

  • OWSCH.bmp
    2.3 MB · Views: 72
  • One-Wire-Protocol.pdf
    136.8 KB · Views: 131

It's a part of this simplified rs232 interface circuit, it will be charged to a negative voltage (via the diode) using the PC side TX (3) pin idle state (-8 ... -12v), and used as a negative power supply for the PC side RX (2) pin via the 4k7, so if the BC557 is on then the PC side pin 2 will be +5v, else appr -7 v. Cheaper than a max232
 
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…