Microcontroller Paper Cutter Interface Circuit Problem

Status
Not open for further replies.
T

Tiwana6330

Member level 1
Joined
Feb 3, 2011
Messages
36
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Visit site
Activity points
1,536
I have a paper cutter knife that runs on 24 volts which is controlled by microcontroller running at 3.3 V. DO-Cut Signal is attached to microcontroller pin. The pin goes high and low but the CN-CUT signal remains at 24 volts. I think there is some problem in resistor values. Can anyone help with what the problem is and how to solve it? Circuit is attached

View attachment error.bmp

thanks
 

this is becouse your baising of mosfet is not happening over there just replace the mosfet
and apply 24 v t0 drain of your mosfet if you are using n channel mosfet
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…