Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Menus grayed out in Orcad? Can't annotate

Status
Not open for further replies.
M

mr_monster

Member level 4
Member level 4
Joined
May 10, 2012
Messages
79
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,964
I have finished a schematic and would like to "reset" the annotation (part designators) from left to right so they will make more sense. I go to Tools --> Annotate but I can't click it since it is in gray. Any idea why is that?

screen_capt.jpg
 

mr_monster said:
I have finished a schematic and would like to "reset" the annotation (part designators) from left to right so they will make more sense. I go to Tools --> Annotate but I can't click it since it is in gray. Any idea why is that?

View attachment 128732
Click to expand...

Go to the leftmost tab - the project navigation tab. In your case it says "Fader.opj". Under Design Resources folder highlight top level .dsn file(or on schematic pages), then click on Tools, then Annotate.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top