Non AMP

Mechanical hole placement in Altium design

Thread starter viperpaki007
Start date Aug 7, 2014

Status: Not open for further replies.

Aug 7, 2014

#1

V

viperpaki007

Full Member level 5

Hi,

How can i put a mechanical hole in PCB using altium designer.

regards

Aug 7, 2014

#2

andre_luis

Super Moderator

Staff member

you can draw a Pad with no metalization; in other words, could perform this by specifying a metalization diameter smaller than hole size.

Status: Not open for further replies.

Similar threads

Z
Altium Designer - NC Drill File Name Extensions
- Started by zildjiansplaash
- Nov 4, 2024
- Replies: 0
PCB Routing Schematic Layout software and Simulation programs
Y
exporting cloud based project in Altium
- Started by yefj
- May 31, 2024
- Replies: 0
PCB Routing Schematic Layout software and Simulation programs
P
Altium making special shapes on PCBs
- Started by Pixelx
- Oct 2, 2024
- Replies: 3
PCB Routing Schematic Layout software and Simulation programs
C
Unrouted net issue when design rule check in Altium
- Started by cupoftea
- Jan 11, 2024
- Replies: 0
PCB Routing Schematic Layout software and Simulation programs
Y
Problem understanding PAD properties in ALtium menu
- Started by yefj
- May 24, 2024
- Replies: 2
PCB Routing Schematic Layout software and Simulation programs