Hello i am trying to interface a board with J-ling EDU Segger debugger shown in the attached photo.
The board has 8pin connection but the jlink device has 20 pin connection.
I have tried to look in the manual bellow to find out what each output pin one that device represents
Hello , on my board i have the 8pin connection where each pin is described as followes:
VSS GND RST TX DIO CLK SWO RX
but on the jlink device from the link bellow i have
Vtref nTRST TDI TMS TCK RTCK TDO RESET DBGRQ 5V-suplly NC GND as shown in the photo bellow
Where do i put the RST TX DIO CLK SWO RX pins they dont have the same names?
Thanks.